Duct cleaning has never been shown to actually prevent health problems. Neither do studies conclusively demonstrate that particle (e.g., dust) levels in homes increase because of dirty air ducts or go down after cleaning. This is because much of the dirt that may accumulate inside air ducts adheres to duct surfaces and does not necessarily enter the living space. It is important to keep in mind that dirty air ducts are only one of many possible sources of particles that are present in homes. Pollutants that enter the home both from outdoors and indoor activities such as cooking, cleaning, smoking, or just moving around can cause greater exposure to contaminants than dirty air ducts. Moreover, there is no evidence that a light amount of household dust or other particulate matter in air ducts poses any risk to health.
Their crew arrived promptly at 7:00 am. Carlos explained what each crew member would be doing. They increased the insulation in my attic. They also discovered that the ducts had been attached to the vents with plain duct tape. The duct tape had become gooey due to heat and had slipped off the vents in many places. This allowed out side air and dust to enter, spreading dust out of the vents. It also allowed cooled air to escape into the attic. The corrected all of the duct work connections. Jeff came to check the work upon completion. He ran tests to verify that the work had been done correctly, and he replaced all of the "regular" light bulbs with cal bulbs. All of the work was done quickly and neatly.
The amount of time air duct cleaning takes can depend on how extensive your duct system is, how old your air ducts are, and whether they have ever been cleaned. On average, expect a standard size home (between 2,000 and 3,000 square feet) to take 2-5 hours for one to two technicians to clean. Here are the proper protocol and equipment you should expect from a professional duct cleaning service, as recommended by the Environmental Protection Agency:
A small number of products are currently registered by EPA specifically for use on the inside of bare sheet metal air ducts. A number of products are also registered for use as sanitizers on hard surfaces, which could include the interior of bare sheet metal ducts. While many such products may be used legally inside of unlined ducts if all label directions are followed, some of the directions on the label may be inappropriate for use in ducts. For example, if the directions indicate "rinse with water", the added moisture could stimulate mold growth.
I moved into a house built in 2003 last year, and spent a lot of time researching air filters because I realize air pollution inside the house is many times higher than outside, and my health and the health of children and youngers can be so adversely impacted by inhaling these indoor pollutants. I spent a lot of money on the best filters because here in northern Kentucky, I discovered I am allergic to something in the air starting in Spring that made me sick for 10 days - sort of a Upper Respiratory Illness. It never occurred to me the previous owner had never cleaned the air ducts, although he had both very young children, two dogs and a cat.
I recently did some remodeling and figured I’d get the air ducts cleaned in our 12 year old home. After obtaining 4 estimates between $572 and a whopping $3,075 for 25 vents and 2 air handlers, I knew I was in for a ride. I read through this blog and decided to use a $79 inspection camera I just found online (Home Depot) to take a look at all my ducts by removing the ceiling grilles first and then try to get into the ducts from the other end. From what I have just learned here, I believe that will take care of my “concerns”.
Internal insulation provides better acoustical (noise) control. Flexible duct is very low cost. These products are engineered specifically for use in ducts or as ducts themselves, and are tested in accordance with standards established by Underwriters Laboratories (UL), the American Society for Testing and Materials (ASTM), and the National Fire Protection Association (NFPA). Many insulated duct systems have operated for years without supporting significant mold growth. Keeping them reasonably clean and dry is generally adequate. However, there is substantial debate about whether porous insulation materials (e.g., fiber glass) are more prone to microbial contamination than bare sheet metal ducts. If enough dirt and moisture are permitted to enter the duct system, there may be no significant difference in the rate or extent of microbial growth in internally lined or bare sheet metal ducts. However, treatment of mold contamination on bare sheet metal is much easier. Cleaning and treatment with an EPA-registered biocide are possible. Once fiberglass duct liner is contaminated with mold, cleaning is not sufficient to prevent re-growth and there are no EPA-registered biocides for the treatment of porous duct materials. EPA, NADCA and NAIMA all recommend the replacement of wet or moldy fiber glass duct material.
I just had my blower module replaced because my AC coil was frozen over. The underside of my coils had a thick mat of dust because I had never had it cleaned. I cleaned it myself by using a soft brush attachement on a shop vac. The inside of the blower appears to have a white/green growth, and I am sure the ductwork of my 30 year old house can’t be in good condition.
I bought a Groupon for an air duct cleaning and deodorizing for $59. I read all of the fine print and it said "unlimited ducts." When they came to perform the service they said it would cost an additional $200 to cover the entire house. I ended up canceling the whole service and the guy who was there do to the work said he is leaving the company because of issues like this. He said 25% of their customers end up canceling when they arrive to do the service because of the dishonest advertising. Later the same day, the manager called me to discuss why I canceled the service. I told her the Groupon was dishonest and intentionally misleading and her response was, "I don't work on the advertising." I told her that as the manager she has some responsibility for what is advertised about the company and she said, "I just work here, I don't own the company." So apparently the management has no responsibilities at Best Air DC, perhaps that is part of the problem. I will never use them again and hope no one else does either. Save your money!
I had them out to clean the ducts, exhaust fans, and dryer vent in my 54 year-old home yesterday. They showed up a bit early and took their time to ensure that all the grunge was gone. I must say...they really earned their paycheck with this place! The father and son duo worked together to remove and clean the register covers, ream out the ducts and vents with a big furry brush/vacuum unit, and vacuum up the mess. They stated that I had the dirtiest ducts they had encountered in 15 years, and took over two hours to tidy them up, finding nails, copper pipe and assorted detritus and emptying the vacuum bag three times in the process. They were here over 2 1/2 hours, yet charged the fee they had quoted me on the phone, as promised. It was not the cheapest price I have seen, but it seemed fair to me. Interestingly, I had this service performed several years ago, by a cheaper company. Based on the amount of dirt and junk that was removed yesterday, I now have my doubts that the previous company really performed the work. Yes, I checked this time! The owner, John, told me that there is another company working under the same name, so make sure that you are getting the Arizona Air Duct Cleaning Company, father and son team, that is being reviewed here. Not all these companies are honest and do what they claim to!
WELL, this summer when I opened them up we had black dust spewing from one of the upstairs vents. It resembled the fuzz that comes off new towels. This prompted us to look into duct cleaning. We heard from someone who had it done several times, said it was worthwhile, and knew of a firm that did a good job. Clean Air America sent a single technician for the appointment and after counting registers and ducts gave me a price of $360.00 which included “sanitizing” the system (a $99 additional fee per can used). The small size of the plenum forced him to connect the 8” round vacuum hose from the truck to the 10” square opening from our humidifier unit. In hindsight, a mistake since it reduced the “negative” pressure in the system.
Air duct cleaning companies are responsible for eliminating dust and other potentially harmful elements that can build up inside the air ducts of your home's cooling or heating system. If you need your air ducts cleaned, you may want to seek an air duct cleaning company that has specific knowledge, qualifications, and experience to ensure your home is properly cleaned and left uncontaminated. This article provides details on how to best choose an air duct cleaning company.
Air duct cleaning is done by heating, ventilation and air conditioning (HVAC) professionals. The pros use industrial-strength, truck-mounted vacuums and powerful brushes and hoses to clean inside the metal ducts that make up your forced air heating and cooling system. The Environmental Protection Agency recommends duct cleaning if there is “substantial visible mold growth inside hard surface ducts, ducts that are infested with vermin such as rodents or insects, or ducts that are clogged with excessive amounts of dust and debris and/or particles are actually released into the home from your supply registers.”
Most organizations concerned with duct cleaning, including EPA, NADCA, NAIMA and the Sheet Metal and Air Conditioning Contractors' National Association (SMACNA) do not currently recommend the routine use of sealants to encapsulate contaminants in any type of duct. Instances when the use of sealants to encapsulate the duct surfaces may be appropriate include the repair of damaged fiber glass insulation or when combating fire damage within ducts. Sealants should never be used on wet duct liner, to cover actively growing mold, or to cover debris in the ducts, and should only be applied after cleaning according to NADCA or other appropriate guidelines or standards.
In addition, the service provider may propose applying chemical biocides, designed to kill microbiological contaminants, to the inside of the duct work and to other system components. Some service providers may also suggest applying chemical treatments (sealants or other encapsulants) to encapsulate or cover the inside surfaces of the air ducts and equipment housings because they believe it will control mold growth or prevent the release of dirt particles or fibers from ducts. These practices have yet to be fully researched and you should be fully informed before deciding to permit the use of biocides or chemical treatments in your air ducts. They should only be applied, if at all, after the system has been properly cleaned of all visible dust or debris.